wire library between arduino uno and adafruit feather

The programming process uses VCC, GND and four data pins. The whole process of loading the bootloader code and burning properly the fuses to make an ATmega microcontroller an 'Arduino' is managed by the Arduino Software (IDE): it provides a specific menu item and allows you to use a variety of programming devices.Īmong the programmers, the 'Arduino as ISP' is the cheapest and most practical solution to burn a bootloader on another Arduino board with ATmega, 32U4 or ATtiny. The ISP programming procedure also includes the writing of fuses: a special set of bits that define how the microcontroller works under specific circumstances. To program the bootloader and provide to the microcontroller the compatibility with the Arduino Software (IDE) you need to use an In-circuit Serial Programmer (ISP) that is the device that connects to a specific set of pins of the microcontroller to perform the programming of the whole flash memory of the microcontroller, bootloader included.

This little (usually 512 bytes) piece of code is called the 'Bootloader' and it is in an area of the memory of the microcontroller - at the end of the address space - that can't be reprogrammed as a regular sketch and had been designed for such purpose. If no connection is detected, the execution is passed to the code of your sketch. The behaviour described above happens thanks to a special piece of code that is executed at every reset of the microcontroller and that looks for a sketch to be uploaded from the serial/USB port using a specific protocol and speed. It is enough to connect it to the computer USB port and press the 'Upload' icon to start a process that transfers your sketch into the Flash memory of the microcontroller. What makes an Arduino what it is? Many things, but one of the most important ones is the way every Arduino board is easily programmed with the Arduino Software (IDE).

Wire library between arduino uno and adafruit feather